plumbing company San Diego CA
plumbing company San Diego CA

How to Fix Slow Water Flow or Low Pressure

We’ve all turned on the faucet only to be met with slow water flow. Whether the water is trickling out or it’s just a bit weaker than usual, low water pressure can be annoying. Slow water flow can be an indication of several issues. By knowing the causes of low water pressure and a few simple solutions you can try, you’ll save lots of money and heartache in the long run.

Shut Off Valves

slow water flow San Diego CAAs simple as this may sound, sometimes slow water flow can be attributed directly to a shut off valve that isn’t completely open. Locate the shut off valves. (They’re usually located underneath most sinks.) Turn the knob counter-clockwise as much as you can. If a partially-shut valve was the cause, your water pressure will increase.

Slow Water Flow from Blockages

If your valves are open all the way and you’re still experiencing slow water flow, then the cause might be a clog. The first place to check is the aerator. The aerator is the cap on your faucet where the water comes out of. It has a screen and, over time, sediment gets caught in it, which impedes water flow. Remove the aerator and clean it thoroughly. Some recommend soaking the aerator in vinegar for a few hours, but you should be able to do a good enough cleaning job without the vinegar. If there was a lot of dirt in the aerator, your water pressure will improve significantly.

If you’ve cleaned the aerator and the water flow is still weak, there may be a clog in the pipes. As time goes by, mineral deposits build up in the piping. That will slow water flow and, eventually, it may even cause your pipes to burst. Don’t let it get any worse – consult a professional. In general, your pipes need to be regularly maintained to ensure they’re functioning properly. Pipes that go ignored will end up costing you in the long run.

Read more about low water pressure at

Posted on by bmpadm in Featured, Plumbing Repairs San Diego